|
How
does the Asspro AP-8 Air Sterilizer
work?
When power is on,
ozone will be generated using a patented "AP Corona
Discharge ozone chip" and the blower drive the ozone
into the open area. This mild ozone (low
concentration of 0.02 to 0.05 ppm) will act as an
neutralize agent to
react with any toxic gases, odor and ammonia (urine
produce ammonia) that present in the air. Ozone will
also kills fungus, air-borne bacteria and viruses by
breaking down its cell. High
humidity country are expose to heavy fungus
growth, which is very
hazardous to our health.
There are 16 combinations setting for the ozone
output. Electronically control using a friendly "dip
switch" as illustrated below. Please use the correct
setting, DO NOT set high ozone output for a
small room. You can sense the concentration of ozone
by smell. Lower down the setting if the smell is
heavy. You will only need a low concentration of
ozone to do the job. The smell of the ozone is like
mild burning smell and this is normal.
How
to install Asspro AP-8?
This is a small and very light machine that easily
install on the wall using 2 screws (guide will be
provided) or place it on the table. Face the grill
downward or side way so that the ozone output will
flow downward, as ozone is heavier than air. AP-8
work best with a good
air circulation. Switch on the ventilator or fan to
make the air circulate. Install at lease 3 meter
away from your sitting position. The smell of the
ozone is like mild burning smell and this is normal.
AP-8 is a low power consumption machine. You can use
a power source from a lighting point or parallel
with lighting point (but lighting point without
dimmer control), or any power source that match the
machine's voltages (110 volts or 230volts).
AP-8 Timer Setting for ozone control output.
There are 4 switches in a dip switch namely 1,2,3
and 4. From the drawing you can see the dip switch
is now set to 1=On, 2=Off, 3=Off and 4=On.
The
table indicate the time in minute (Min). ON time
interval of 1,3,12,18 and OFF time interval of
3,10,15,20.
Example: If you want to set to ON time for 1 min and
OFF time for 15 min, then the switch position will
be 1=Off, 2=Off, 3=On and 4=Off
If
you want ON time for 12 min and OFF time for 5 min,
then set the position to 1=On, 2=Off, 3=Off and
4=Off
Please also refer to the recommendation table below
for best result.
|
